Polymer tile adhesive(GRANASIL_T.S)

Polymer tile adhesive(GRANASIL_T.S)

Properties and benefits:


– Very high resistance Ease of installing tiles – Saving time and money – Strength against building stresses – Installation without destroying and removing the old work – Suitable flexibility and very high useful life – Sealing and not dissolving in water after drying -Can be used on cement, concrete, stone, old tile, mosaic and plaster walls




It is a mixture of synthetic polymers and adhesion enhancers along with micronized inorganic fillers and waterproofing chemical compounds. This product has very high adhesion as well as compressive and tensile strength above the standard range in different cycles of cold and heat in submerged environments. It is in water and dry environments. In such a way that after drying and sticking, it will not be in water in any way


Physical and chemical state:



Pasting tiles on old tiles Items that require high execution speed Sticking tiles on plaster, wood or stone surfaces Structures that have stretch, contraction and volumetric expansion Can be used on the bathroom wall, kitchen, corridors Installing tiles, ceramics and small stones on plaster, wooden or stone surfaces




The surface must be solid and free of loose particles. The most suitable infrastructure, including reinforced and sponge concrete, cement mortars and old plasters, should be in good condition and free from oil, pollution and dust.If the work surface already has another cover, such as wall paper, First, the paper should be removed from the wall and then with the help of primer (putty), foundation has done Sub works done with plaster must be done before installing tile adhesive To be smeared with primer (putty). To install the tile, stand on the tile First, remove any grease from the surface of the tile with an ax Remove some of the old tile glaze. Using a trowel or combed spatula, apply the glue to a maximum width of one meter Spread a square and thickness of 3 to 4 mm on the wall, within 5 to 10 Minutes Install the tiles on the adhesive. Tiles installed on the wall After 48 hours, they reach their final strength, and after this period, you can He started the tying and two days after the tying, the desired level is acceptable is used. For installation with tile adhesive, at least the back of the tile should be glued Tiling should not be done in cold weather and below zero degrees, because if the glue freezes, complete lack of adhesion will occur.


Health and safety:

This product is not a hazardous substance, however, it is better to avoid contact with skin and eyes and use gloves and glasses, in case of contact, wash with plenty of water.



The amount of consumption depends on the surface of the work and how the ridges are on the back of the ceramic tile and is usually equal to 2.5 kg per square meter.



It can be stored in containers in the original package at a temperature of 10 to 40 degrees Celsius for 6 months


Note: Do not use paste tile adhesive in water retaining structures such as swimming pools, you can use powdered tile adhesive in water retaining structures. Consuming less and more than the permitted range of this additive or using multiple substances at the same time Addition of concrete must be done with the permission of experts from the technical department of Granabton Chemical Industries. Consumption less and more than the permitted range of this additive or the simultaneous consumption of multiple concrete additives must be done with the permission of the experts of the technical department of Granabtan Chemical Industries Company.




هیچ دیدگاهی برای این محصول نوشته نشده است.

اولین نفری باشید که دیدگاهی را ارسال می کنید برای “Polymer tile adhesive(GRANASIL_T.S)”

Your email address will not be published. Required fields are marked *